Instruction manual
10
P-2000 7.1 Channel Preamp/Processor/Tuner
Instruction Manual
11
Remote Control
The P-2000 Universal Learning Remote Control duplicates every function
available from front panel of the preamp/processor and more. It is designed
to access all the conguration and operating menus of the P-2000. These
are displayed on the FRONT PANEL DISPLAY, as well as the ON SCREEN
DISPLAY (OSD). The Remote Control contains an extensive library of IR
codes and may be programmed to operate a wide range of other audio and
video components. Additionally, you can teach the remote to control other
audio/video units not included in the unit’s built-in memory by entering
their particular device codes (see page 39).
Many of the buttons on the Remote Control serve multiple functions,
depending on the source device being controlled. The list below describes
each button’s main functions. For a complete description of their use, please
refer to the section titled “Remote Control Setup and Operation”.
1 Status LED Indicator (see page 37)
Indicates when the remote control is in Programming or Learning mode
and ashes to indicate success or failure of these functions.
2 Source Selection buttons (see page 30)
When the P-2000 is in Standby mode, pressing one of these buttons turns
the unit on and selects that source as the current input.
If the P-2000 is already on, pressing one of these buttons selects that
source as the new input.
In both cases, once properly programmed, the remote control also oper-
ates the source device selected.
The AUD button sets the Remote to control the P-2000.
The Source button selected will light whenever you push one of the
Remote’s function buttons to indicate that you have sent a command
to that component. If the command you have pressed is one that is not
available on that type of unit (i.e. P SCAN on a CD player) the source
button will not light, although you have pressed that button.
3 POWER button (see page 27, 30)
Returns the P-2000 to standby mode when the unit is on.
4 MUTE button (see page 31)
Mutes the main volume of the P-2000. Does not mute the second zone.
5 Multi-zone button (see page 36)
Press the MULTI button to call up and cycle through the Multi-zone menu
options on the FRONT PANEL DISPLAY and the OSD, if active.
6 TEST button (see page 27)
Outputs an audio test tone for calibrating and setting the speaker levels.
Pressing the button again restores the audio output from the previously
selected input source.
7 TRIM button (see page 33)
Activates the Channel Trim function. Pressing the button cycles through
all the channels individually for trim adjustment up to 10dB above or
15dB below the master volume setting, in 1dB steps. (1dB is the smallest
amount of sound change readily perceptible to human hearing.)
P-2000 Remote Control
1
14
15
16
17
18
19
26
13
11
10
9
8
20
7
6
4
25
3
23
2
24
22
12
21
5
Remote Control