User manual

ATL Berkshire 5000 User Manual, Release 2.2.1

- - - E a s y s e t u p - - -

P r e s s a n y k e y .

2.2 Easy Setup

Before you can use the phone to make calls, you should first configure the phone settings. The

Easy Setup wizard will guide you to set up the phone easily.

0. First of all, the start screen of Easy Setup will be shown as follows:

- - - E a s y S e t u p - - -

P r e s s a n y k e y .

1. Press any button to continue. The following screen will then be shown:

I s D H C P a v a i l a b l e ?

1 = Y e s, 2 = No

2. If DHCP service is available on your network (i.e. you get your IP address dynamically),

press 1 and jump to Step 7. If not, press 2 and the following screen will then be shown:

I P A d d r e s s

3. Press the ‘Menu / Delete’ button to delete the current setting if necessary. Input the IP

address of the phone with the keypad. The “.” character can be inputted by pressing the “*”

button. Press the ‘OK’ button to confirm and save the setting. If the setting is saved, the

following screen will then be shown:

S u b n e t M a s k

4. Change the subnet mask if necessary. If the setting is confirmed and saved, the following

screen will then be shown: