User guide

2.2 SETTING TIME AND DATE
If CLI is provided on the line that the Berkshire
800 is connected to, the time and date may be
set by calling the telephone from an alternative
line, or waiting for a call to be received.
ALTERNATIVELY:
With the Berkshire 800 “On-Hook”, press the
“MENU/ENTER” key. The LCD will display the
following:
SET MEMORY
Press the UP () or DOWN () key until “SET
TIME / DATE” is displayed on the LCD
.
Press the “MENU/ENTER” key. The LCD will
display the following:
HR : MIN DAY / MONTH
SET TIME/DATE
THE HOURS
"00" WILL
FLASH
The “HOURS” digits will be shown flashing.
Use either the UP () or DOWN () key to
increment (decrement) the “Hour” digits (24
hour clock), or else use the keypad to directly
enter the current hour.
Once the “hour” has been set, press the ()
key. The “Minutes” digits will then flash.
Set the “Minutes” in the same manner,
followed by the “Day” (01-31) and “Month”
(01-12).
Press the “MENU/ENTER” key to confirm the
Time and Date, or at ANY TIME press the
“CANCEL” key or wait till the telephone “TIMES
OUT” (Approx 10 Seconds – See Section 12.5)
to retain the previous settings.
The LCD will display the following: (Time and
Date set, (For this example): 3.30pm, 15
th
August)
NO CALL
15 : 30
15 / 08
2.3 DISPLAY CONTRAST
Whether mounting the Berkshire 800 on a wall
or simply sitting the telephone on a desk, it may
be necessary to adjust the contrast on the LCD.
With the telephone “On-hook”
Press the “MENU/ENTER” key. The LCD will
display the following:
SET MEMORY
Press the UP () or DOWN () key until
“DISPLAY CONTRAST” is shown on the LCD
display.
Press the “MENU/ENTER” key. The current
setting of the display contrast will flash on the
LCD display. (The Factory Default is “4”).
DISPLAY CONTRAST
4
SHOWN
FLASHING
Press the UP () or DOWN () key until the
required setting (1–8) is obtained.
Press the “MENU/ENTER” key to confirm the
setting.
If the MENU/ENTER key is pressed the screen
returns to its “On-hook” state.
3. Making a Call
3.1 USING THE KEYPAD
The required number may be pre-constructed,
using the keypad and then dialled by lifting the
handset or pressing the “HEADSET/DIAL” key,
to make the call using the headset (if one is
connected) or handsfree modes.
To use the telephone in headset mode, ensure
that a compatible headset is connected to the
“HEADSET” socket, situated on the left hand
side of the Berkshire 800 telephone.
The required number may also be dialled after
lifting the handset or pressing the
“HEADSET/DIAL” key.
Page 4 of 20