Operating instructions

24
Possible faults
Fault Possible cause Removal
Machine fails to start after
switching on or switches off
during idle running
• Power failure
• Extension cable defect
• Motor or switch defect
• Saw blade sticks
• Replace fuse
• Check cable, no longer use defect cable
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Remove the cause of the jam.
Machine stops while cutting
• Saw blade blunt
• Feed too large
• Motor protecting switch has tripped
• Replace saw blade
• Allow the motor to cool off and then continue work
using less pressure
• Switch motor back on after cooling ”Motor protection”,
p. 21
Workpiece sticks when
feeding
• Saw blade blunt
• The longitudinal or parallel stop is not
parallel to the saw blade, see p. 23
• Hold the workpiece firmly and switch the motor off
immediately. The have the saw blade sharpened or
renew
• Readjust the scale, see p. 23
Burn marks at the cut edges
• Saw blade is unsuitable for the cutting
task or blunt
• Replace saw blade or have it sharpened
Chip exit blocked
• No exhaust suction connected
• Suction too weak
• Switch off saw and remove chips
• See “Safe working”
Motor running, saw blade will
not turn.
• V-belt too loose or defect • Contact an authorised customer service workshop
Technical data
Type (model) RTS 250 B (T 250)
Motor output P
1
1500 W (S6 40 %)
Mains voltage 230 V~
Mains frequency 50 Hz
Saw blade speed 5700 min
–1
Mains fuse 10 A inert
Hard metal saw blade ∅ maximum 254 mm
Hard metal saw blade ∅ minimum 245 mm
Saw blade thickness 1,6 mm
Cut width 2,4 mm
Number of teeth 24
Thickness of Splitting wedge 2 mm
Saw blade location hole 30 mm
Cutting speed (at maximum saw blade ∅) 75
m
/
s
Cutting height at 90° (for maximum saw blade ∅) approx. 76 mm
Cutting height at 45° (for maximum saw blade ∅) approx. 68 mm
Bevel cut adjustment (swivelling range) 0° - 45°
Table size (with length and width extension) 910 x 945 mm
Table height (with stand) 810 mm
Table length extension 320 mm x 440 mm
Table width extension 550 mm x 250 mm
Weight (with stand) ca. 23 kg
Exhaust outlet guard ∅ 35 mm
Exhaust outlet ∅ 35 mm
Commercial, small dust collectors or industrial vacuum cleaners are used for vacuuming.