Operating instructions

Fitting and adjusting the longitudinal stop
L
Make sure that the fences are correctly adjusted.
(See "Working instructions")
Fit the longitudinal stop (C) to the saw table plate.
1. Push the longitudi-
nal stopper (handle
with integrated ad-
justing magnifier)
into the guide profile
on the bench.
2. Set the required
position with the aid
of the setting
magnifying glass.
3. Press the stopper
ruler ( C ) up against
the bench and fix the
lon-gitudinal stopper
by pressing lever ( D
) down.
4. In order to ensure that the stop is actually parallel to the saw
blade, measure the distance from the saw blade at the
front and rear.
23
Working instructions
Before commencing work, ensure the following:
 Protective guard, splitting wedge and saw blade ok?
 Saw blade sharp?
 Stoppers (fences) ready for use and pushstick to hand?
 Workplace tidied?
 You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Also, note the following important points:
 Place yourself outside of the area of danger
 Place your hands flat on the workpiece with fingers closed.
Only guide the workpiece manually up to the front edge of
the protective hood.
 Never remove loose splinters, chips, or similar by hand.
Ensure that you always comply with the safety
instructions given on p. 19 ff.
Cutting narrow workpieces
(Width less than 120 mm)
Push the workpiece forward with both hands, in the area
of the saw blade, use the pushstick (E)
When working on very flat and narrow workpieces (Width
30 mm and less) use the lower guide are of the fence
scale (F), see picture.
Cutting wide workpieces
 With the flat of the hand and the fingers closed, push the
work piece to be cut along the stop.
Cross cuts / mitre cuts
 Push the transverse stop into one of the guide grooves on
the table.
 Set the transverse stop to the required angle and apply the
stop rails (G).
 Push the longitudinal stop (C) into the required position, so
that the work piece can be securely held in place.
 Place the workpiece to be cut against the stop rails.
 Hold the workpiece firmly in place and push it past the saw
blade using the transverse stop. Use the pushing bar if
necessary.