Operation Manual

20
Fault Possible cause Remedy
Machine does not work with full
performance
 Lithium ion battery run down
 Lithium ion battery defective
 Charge the lithium ion battery
 Contact the customer service
Machine does not cut properly  Cutting tool blunt/worn  Have the cutting tool reground or replace it
Machine cuts with interruptions
 ON/OFF switch defective
 Internal fault
 Contact the customer service
Knives get hot
 Missing lubrication => friction
 Knives are edgeless
Â
Cutting tool has nicks
 Lubricating of knives
 Arrange sharpening of knives
Â
Check the cutting tool
Motor is running, knives do not
move
 Knives are blocking
 Internal fault
 Remove object
 Manufacturer or responsible customer ser-
vice respectively must be called
Cutting time with fully charged battery
too short
 Missing lubrication => friction
 Knife has to be cleaned
 Rechargeable battery is low
 Battery service life exhausted
 Lubricating of knives
 Clean the knife
 Charging the rechargeable battery
 Replace the rechargeable battery
T
T
e
e
c
c
h
h
n
n
i
i
c
c
a
a
l
l
D
D
a
a
t
t
a
a
HSC
Type 580/18
No-load speed n
0
1200 min
–1
Cutting length 510 mm
Cutting distance 14 mm
Weight with rechargeable battery approx. 2,80 kg
Hand-arm vibration to EN 1033/DIN 45675 a
vhw
= < 2,3 m/s²
Measuring uncertainty K 1.5 m/s²
Sound power level L
wa
(according to regulation 2000/14/EG) measured sound power level 86,8 dB (A)
guaranteed sound power level 94 dB (A)
Sound pressure level L
PA
(according to regulation 2000/14/EG) 81 dB (A)
Measuring uncertainty K
PA
/ K
WA
3.0 dB (A)
Rechargeable battery AB 18/01
Rated voltage 18 V DC
Capacity 1,3 Ah
Charging time approx. 1 h
Operating time approx. 25 min
Charger ALG 18/1500
Mains voltage / Mains frequency 230V 50 Hz
Charging current 1,5 A
Permissible charging temperature range 10 – 40 °C
Weight 0,5 kg