Operation Manual

20
Fault Possible cause Remedy
Machine cuts with interruptions
 ON/OFF switch defective
 Internal fault
 Contact the customer service
Knives get hot
 Missing lubrication => friction
 Knives are edgeless
Â
Cutting tool has nicks
 Lubricating of knives
 Arrange sharpening of knives
 Check the cutting tool
Motor is running, knives do not
move
 Knives are blocking
 Internal fault
 Remove object
 Manufacturer or responsible customer ser-
vice respectively must be called
Cutting time with fully charged battery
too short
 Missing lubrication => friction
 Knife has to be cleaned
 Rechargeable battery is low
 Battery service life exhausted
 Lubricating of knives
 Clean the knife
 Charging the rechargeable battery
 Replace the rechargeable battery
T
T
e
e
c
c
h
h
n
n
i
i
c
c
a
a
l
l
D
D
a
a
t
t
a
a
HSC
Type 560/18
No-load speed n
0
1400 min
–1
Cutting length 510 mm
Cutting distance 11 mm
Weight with rechargeable battery approx. 2.70 kg
Hand-arm vibration to EN 1033/DIN 45675 a
vhw
= < 4.26 m/s²
Measuring uncertainty K 1.5 m/s²
Sound power level L
wa
(according to regulation 2000/14/EG) measured sound power level 95.4 dB (A)
guaranteed sound power level 100 dB (A)
Sound pressure level L
PA
(according to regulation 2000/14/EG) 90 dB (A)
Measuring uncertainty K
PA
/ K
WA
3.0 dB (A)
Rechargeable battery AB 18/02
Rated voltage 18 V DC
Capacity 1.3 Ah
Charging time approx. 3 h
Operating time approx. 25 min
Charger ALG 18/300
Mains voltage / Mains frequency 230V 50 Hz
Charging current 300 mA
Permissible charging temperature range 10 – 40 °C
Weight 0.15 kg