Operation Manual

20
T
T
e
e
c
c
h
h
n
n
i
i
c
c
a
a
l
l
d
d
a
a
t
t
a
a
s
s
GSC GSCT
Type 3,6 3,6
Rated battery voltage 3.6V 3.6V
Capacity 1.3Ah 1.3Ah
Rechargeable battery Lithium ion Lithium ion
Cutting width - grass shear 80 mm 80 mm
Cutting length - shrub shear 110 mm 110 mm
Distance of knives 8 mm 8 mm
Operating time, approx. 40 min 40 min
Charging time, approx. 4 h 4 h
Sound pressure level L
PA
74,6 dB (A)
Measured sound power level L
WA
86,4 dB (A)
Measuring uncertainty K
PA
/ K
WA
3.0 dB (A)
Guaranteed sound power level L
WA
90 dB (A)
Hand arm vibration 1.63 m/s
2
Measuring uncertainty K 1.5 m/s
2
Telescopic handle -
O
Weight of the shrub shear 0.64 kg 1.07 kg
Weight of the grass shear 0.55 kg 0.99 kg
Charger
Input 230V~ 50 Hz
Output 6V, 500mA
Protection class II
P
P
o
o
s
s
s
s
i
i
b
b
l
l
e
e
f
f
a
a
u
u
l
l
t
t
s
s
Before each maintenance and cleaning work: ― switch off device
― wait until the cutting tool comes to a stop
― wear protective gloves
 After each fault clearance, put into operation and recheck all security installations.
Fault Possible cause Removal
Machine does not start after switch-
ing on
 Lithium ion battery run down
 Lithium ion battery defective
 ON/OFF-switch defective
 Internal fault
 Charge the lithium ion battery
 Contact the customer service
Machine with assembled telescopic
handle does not start after switch-
ing on
 Telescopic handle not correctly en-
gaged in its holder
 Check the plug-type connections
Machine does not work with full
performance
 Lithium ion battery run down
 Lithium ion battery defective
 Gear unit contaminated
 Charge the lithium ion battery
 Contact the customer service
 Clean the gear unit (see section "Cleaning")
Machine does not cut properly
 Cutting tool blunt/worn  Have the cutting tool reground or replace it
Machine cuts with interruptions
 ON/OFF switch defective
 Internal fault
 Contact the customer service
Engine is running, cutting device
does not move
 Cutting device blocked
 Internal fault
 Remove object
 Manufacturer or responsible customer service
must be called
Cutting device gets hot
 Missing lubrication => friction
 Cutting blades are blunt
 Cutting tool has nicks
 Oil the cutting device
 Have the cutting tool reground or replace it
 Check the cutting tool
Cutting time with fully charged
battery too short
 Missing lubrication => friction
 Cutting blades contaminated
 Rechargeable battery is low
 Battery service life exhausted
 Oil the cutting blades
 Clean the cutting blades
 Charging the rechargeable battery
 Contact the customer service