User Guide

14
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
a
a
l
l
f
f
a
a
u
u
l
l
t
t
s
s
Before each fault elimination:
− Switch off device.
− Wait for standstill of the garden shredder.
− Pull out mains plug.
Fault Possible cause Removal
Motor does not start.
− No power supply.
− Mains cable defective.
− Upper part of the enclosure not properly
closed (safety shut-off is activated).
− Check fuses.
− Have these checked (electrician).
− Close and bolt down upper part of the enclosure cor-
rectly, remove any dirt present.
Motor hums,
but does not start.
− Cutters blocked.
− Capacitor faulty.
− Switch machine off, disconnect mains plug, and clean
interior of machine.
− Have machine repaired by manufacturer or approved
company.
Reduced cutting perform-
ance.
Knife edges became blunt. Turn the knife or replace it with a new set of knives.
Device starts but blocks
under slight load and cuts off
via protective motor switch.
Extension cable too long, or cross-section
too small. Socket too far from mains sup-
ply and cross-section of mains cable too
small.
Extension cable at least 1.5 mm², maximum 25 m long. If a
longer cable is used, minimum cross-section 2.5 mm².
T
T
e
e
c
c
h
h
n
n
i
i
c
c
a
a
l
l
d
d
a
a
t
t
a
a
Model
2300 2500
Name AH 501 AH 500
Motor AC-Motor 230 V~, 50 Hz, 2800 rpm, including automatic motor brake
Motor rating P
1
S6 - 40 % 2300 W 2500 W
Current consumption I 10,4 A 11,3 A
ON/OFF-switch with Motor protection switch, electrical safety cut-out, zero-voltage initiator
Weight 18,5 kg 18,5 kg
Sound pressure level at work L
PA
(measured to 2000/14/EC)
83 dB (A) / K = 3 dB (A)
Measured sound power level L
WA
(measured to 2000/14/EC)
103 dB (A)
Guaranteed sound power level L
WA
(measured to 2000/14/EC)
104 dB (A)
Max. branch diameter
(only for freshly cut wood)
∅ max. 40 mm ∅ max. 40 mm
Safety class I
Protection class IP X4
Mains fuse
Switzerland
UK
16 A time-lag
10 A time-lag
13 A time-lag
16 A time-lag
--
13 A time-lag