Operation Manual

15
Reduced output
One edge of the knife has become blunt:
Turn knife so that you can use the other edge.
All knive edges have become blunt:
Replace with new set of knives (order-no. 382425).
M
M
a
a
i
i
n
n
t
t
e
e
n
n
a
a
n
n
c
c
e
e
a
a
n
n
d
d
c
c
l
l
e
e
a
a
n
n
i
i
n
n
g
g
• Each time before starting maintenance work:
− Switch off the motor and pull out the mains plug.
− Wear protective gloves to prevent injury.
The cutters will not come to a standstill immediately after
cut-off. Before starting any service work wait until all parts
are stationary.
Be sure to have removed any tools from the machine after
completion of service work.
• Generally garden shredders require little maintenance. To
maintain their efficiency and a long life, observe the fol-
lowing:
− Keep vent slits clean and free from obstructions.
− Check the locking screws (tighten where necessary).
− Clean the device after shredding.
To clean your product only use a warm moist cloth and a soft
brush.
Never use cleaning agents or solvents. Otherwise the device
may be damaged irreversibly. Plastic parts may be corroded
by chemicals.
− Do not clean the machine with running water or high-pressure
cleaners.
After each operation treat bare metal parts with an environment-
compatible biodegradable spray oil to protect them against corro-
sion.
G
G
u
u
a
a
r
r
a
a
n
n
t
t
e
e
e
e
Please observe the enclosed terms of guarantee.
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
a
a
l
l
f
f
a
a
u
u
l
l
t
t
s
s
Before each fault elimination:
− Switch off device.
− Wait for standstill of the garden shredder.
− Pull out mains plug.
Fault Possible cause Removal
Motor does not start.
− No power supply.
− Mains cable defective.
− Upper part of the enclosure not properly
closed (safety shut-off is activated).
Retaining basket unlocked
− (safety cut-out device of the retaining
basket has tripped)
− Check fuses.
− Have these checked (electrician).
− Close and bolt down upper part of the enclosure cor-
rectly, remove any dirt present.
− Lock the retaining basket
Motor hums,
but does not start.
− Cutters blocked.
− Capacitor faulty.
− Switch machine off, disconnect mains plug, and clean
interior of machine.
− Have machine repaired by manufacturer or approved
company.
Reduced cutting perform-
ance.
Knife edges became blunt. Turn the knife or replace it with a new set of knives.
Device starts but blocks
under slight load and cuts off
via protective motor switch.
Extension cable too long, or cross-section
too small. Socket too far from mains sup-
ply and cross-section of mains cable too
small.
Extension cable at least 1.5 mm², maximum 25 m long. If a
longer cable is used, minimum cross-section 2.5 mm².