User Guide

15
Chapter 3: Setup
• Log-in to WebPAM (page 15)
• Access a Host PC (page 18)
• Recommended Initial Settings (page 18)
• Create a New Logical Drive (page 21)
• Log-out of WebPAM (page 25)
• Internet Connection using WebPAM (page 26)
• Run WebPAM without Network Connection (page 26)
After installation, the next step is to log into and configure WebPAM.
Log-in to WebPAM
Double-click on the WebPAM icon on your Windows desktop (right).
Or,
1. Launch your Browser.
2. In the Browser address field, type the entry explained below.
If you did not choose the External Security option during WebPAM
installation (see page 11), use the Regular connection.
If you chose the External Security option during WebPAM installation (see
page 11), use the Secure connection.
Regular Connection
• WebPAM uses an HTTP connection . . . . . . . . . . . . . . . . . . . . .http://
• Enter the Host PC’s IP address . . . . . . . . . . . .127.0.0.1 or localhost
• Enter the Port number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . :8080
• Add to launch WebPAM. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ./ati
Together, your entry looks like this:
http://127.0.0.1:8080/ati or http://localhost:8080/ati
Secure Connection
• WebPAM uses a secure HTTP connection . . . . . . . . . . . . . . .https://
• Enter the Host PC’s IP address . . . . . . . . . . . .127.0.0.1 or localhost
• Enter the Port number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . :8443
• Add to launch WebPAM. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ./ati
Together, your entry looks like this:
https://127.0.0.1:8443/ati or https://localhost:8443/ati