User Guide

Installing the Fire GL4 23
4 Click the button corresponding to the type of installation you
want. If you select Custom, a list of software components will
be displayed. Select the check boxes to specify the components
you want to install.
5 Click Next to continue the installation.
6 When the ATI FIRE GL Install dialog displays the components
to be installed click on Next. (Depending on which components
you chose different windows might appear. Click on the
corresponding buttons to continue the installation.)
7 When the Installation complete message appears click Next
again. This will restart your computer.
8 After Windows 2000 reboots, the Found New Hardware
message displays the Digital Signature Not Found dialog
and prompts you Do you want to continue the
installation? Click Yes to install and start the drivers.
9 Click Start > Settings > Control Panel > Display >
Settings, or right-click on the Windows desktop, select
Properties and Settings.
10 Set the resolution (Screen area), and color depth that best suit
your requirements and your monitor's performance.
11 Click the Advanced button and select the Monitor tab.
12 Set the refresh rate for the monitors connected to the Fire GL4
graphics accelerator in your system.
Note: Use the ATI Monitor and DualScreen dialogs to adapt
each monitor's settings in a dual-monitor configuration.
13 Click OK until you are on the Windows desktop.
Note
Refer to your Windows 2000 online help and
documentation for further information on using the
Monitor and Settings dialogs.