User Guide

Introducing the Fire GL4 7
Quick Installation
• Brief instructions on how to get to work with the Fire GL4 in the
shortest possible time.
•
Recommended for experienced users and system administrators
only.
•
For more detailed information on installation and operation of
your graphics accelerator, please refer to the corresponding
sections of the Fire GL4 User’s Guide.
Installation Steps
1 Un-install the drivers and software for your old graphics card.
2 Set the display driver to Standard VGA.
Disable any on-board graphics solution on the motherboard.
3 Shut down and disconnect your computer system.
4 Remove the installed (AGP, PCI, or ISA) VGA card.
5 Install the new Fire GL4 card.
6 Reassemble and connect your computer system.
7 Install the Fire GL4 drivers and configuration software from the
Fire GL CD:
•
••
• automatic Quick Start utility or
•
••
• Start > Run > X:\START EXE
where X is the drive letter of your CD-ROM drive