Owner`s manual

Page 11, Data Sheet 4020, rev: Saturday, October 06, 2007
5) After converting the picture back to an RGB mode file,
you might need to rotate the picture to a ―portrait‖
presentation (vertical). Next, you will need to re-size the
picture to something about 4x5 inches @ 300 ppi. If the
picture is only3.5 x 5 inches that is OK. But, it MUST be
set to a resolution of 300 ppi and it must be in ―portrait‖
presentation (vertical).
Next, create a new, blank, white canvas and be sure that it
is set to RGB @ 300 ppi.
Now, drag the B&W picture (that is in RGB mode) onto
the new canvas and position it in the upper, left-hand
corner as shown to the right.
PRESTO!! You have just created your very own
calibration test image!
Wasn’t that easy!
Now, you can go on to the next page in this document.