Specifications

ATI Audio Inc. ■ Tel: [phone] ■ Fax: [phone] ■ [e-mail] ■ www.
audio.com
tion. The MX101 provides a high-level line output that will drive either balanced
or unbalanced external loads of 600 ohms or higher. The XLR output may also
be jumper-plug programmed for microphone level output.
A HEADPHONE switch selects either full program or split program and cue. A
recessed, thumbnail operated headphone level control minimizes panel clutter
and once set, tracks the MASTER output. A pre-fader cue from input one or an
external director’s CUE INPUT from a rear panel jack feed the headphone cue
circuit thru an internal trimpot.
An EXPANSION INPUT to the mixing buss allows interconnection of two mixers
or the addition of one or more companion XP100 Mic/Line Input Expanders. All
panel controls and connectors are clearly labeled.
MX100 AND MX100C STUDIO MIXERS
Both the MX100 and the MX100C also provide three inputs with front panel se-
lection of microphone or line input levels. Phantom power and input stage gain is
DIP switch programmable for any input. Phantom power is disabled in the line
input mode. The MASTER level control feeds a high level output stage which
comfortably drives either balanced or unbalanced output loads of 600 ohms or
greater. A bright LED VU meter and headphone amplifier monitors the program
output. The output may be set to line or microphone level by moving an internal
jumper plug. The MX100C adds a switched low distortion compressor/limiter and
a peak-indicating LED to the basic MX100 Mixer. A rear panel Expander input
allows interconnection of two mixers or the addition of one or more companion
XP100 Input Expanders.
XP100 INPUT EXPANDER
The XP100 Input Expander provides four (4) additional MIC/LINE switchable in-
puts and plugs into the Expansion Buss input of the mixer. 24V phantom power is
available for each input via internal jumper plug selection. The XP100 inputs pro-
vide a fixed 40dB microphone gain and unity (0dB) gain for line inputs. The
XP100 is supplied with interconnecting expansion cables for the audio and DC
connections to the MX101, MX100 or MX100C.
POWER
A mixer and up to two companion XP100 units can comfortably share a single
external WA100-1 24VDC/400mA wall mount AC/DC power supply. A mixer and
a single expander can be powered from a DCA100-1 DC converter or a PPA-1 or
PPA-2 rechargeable battery pack.