User guide

Appendix C Using the Optional Service Processor C-7
6. Once in the GUI, go to the Lan Config section and enter the correct IP address and
gateway for the system. Also, if needed, enter the MAC address of the Broadcom
NIC.
Make sure that you enter the IP address and gateway for the SMDC card, and not for
the system.
7. Go to the User and Password Settings section in the GUI and enter passwords for
all user names.
8. Verify that the firmware is v4.11 or higher.
The firmware version is listed at the lower right corner of the GUI. Firmware v4.12 is
required for soft power off.
9. If necessary, load new firmware using the Flash Firmware section of the GUI.
10. Press the ESC key to exit out of the GUI.
C.3.2 Setting Up the System BIOS
The minimum BIOS requirement is v1.0.7. This BIOS version is available on
Supplemental CD v1.2 or later.
See the following table for key sequences that replace the function keys in BIOS
v1.0.7 and later.
Note – When using the ESC sequences above, press the ESC key, then the other key.
Repeatedly pressing the keys can hang the LAN on the SMDC card. If this occurs,
you must manually reboot the system using the system reset button.
Function Key New Key Sequences for BIOS v1.0.7
F1 F1+ F1
F2 F2+F2
F3 ESC+3
F4 ESC+4
F8 ESC+8
F12 ESC+B
ESC ESC+ESC
CNTRL-ALT-DEL ESC+C