User`s guide

90 CrossFire™
3 Adjust the Adaptive Anti-Aliasing control slider to the desired
setting.
Set Catalyst™ A.I. settings
1 From the Tree View pane, expand 3D.
2 Click Catalyst™ A.I.
3 If necessary, clear the check mark from Disable Catalyst™ A.I.
4 Click and drag to slider to the desired setting.
Apply your settings
1 Click Apply to save your changes and leave the Catalyst™ Control
Center open.
2 Click OK to save your changes and exit the Catalyst™ Control
Center.
Discard your settings
•Click Discard to ignore any unsaved changes and restore the
settings that existed when the Catalyst™ Control Center was
opened or the last time Apply was used. Discard does not close the
Catalyst™ Control Center.
Clicking
Discard applies to all features of an aspect, not just the feature in
the current view.
Change motherboard BIOS settings
Some motherboards may have a system BIOS option to switch between
single or dual PCIe™ slot support. The default setting may be single slot
support.
Refer to the motherboard’s manual for information to enable dual PCIe™
slot support.
For more information see the CrossFire™ Web page at:
ati.com/crossfire
CrossFire™ graphics card connections
In order for CrossFire™ to function the interconnect cable must be
correctly connected to both the Master and Slave graphics cards.
1 Connect the DMS-59™ connector of the interconnect cable to the
DMS-59™ connection on the Master card.
[e-mail] -- POWER COLOR
-- 202.133.241.51 -- Sunday, December 25, 2005