User guide

Backplate Connections

Figure 2–2 ATI TV Wonder™ 650 Backplate

The following connections are available on the backplate of your tuner card:

1 ANT IN. Coaxial input for digital TV antenna (ATSC)

2 S-VID. Video input for S-Video (direct) or composite connection with

adapter (included)

3 TV IN. Coaxial input for analog TV or FM radio

4 AUDIO. 3.5MM stereo connection for audio input

Hardware Installation

To install your hardware:

1. Turn off the computer, monitor, and other peripheral devices.

2. Unplug the computer's power cord, and disconnect all cables from the back

of your computer.

Caution:

Wait approximately 20 seconds after unplugging the power cord before

disconnecting a peripheral or removing a component from the

motherboard to avoid possible damage to the motherboard.

3. Remove the computer cover. If necessary, consult your computer's manual

for help in removing the cover.

Caution:

Remember to discharge your body's static electricity by touching the

power supply or the metal surface of the computer chassis before touching

the motherboard or components.

4. Locate an available x1 PCI Express slot and, if necessary, remove the metal

backplate cover.

5. Align your card with the slot, then press the card in firmly until it is fully

seated.

6. Screw in or fasten the card securely and replace your computer cover.

7. Reconnect any cables you have disconnected, and then plug in the

computer’s power cord.

Installation

P/N 117-70408-10