User`s guide

74 007-4701-003
4: Installing and Removing Customer-Replaceable Units
Accessing the System’s Internal Components
Many of the procedures in this chapter require the removal of the top cover, a frame rail,
or a support bracket in order to access the internal components you are removing or
replacing. This section describes how to remove and replace these items.
Opening the Cover
Use the following steps to open the cover:
1. To remove the module’s top cover and access the internal system components,
remove the ten Phillips screws as shown in Figure 4-1.
2. Lift the hinged cover into the fully open position.
Figure 4-1 Opening the System Cover