User`s guide

194 007-4701-003
B: Installing Silicon Graphics Prism Modules Into a Rack
Removing a Rail-Mounted Module from a Rack
To remove a module from a rack, follow these steps:
1. Power off the module.
2. Disconnect all of the cables at the rear of the module.
Warning: Components may be hot. To avoid injury, allow the components to cool for
approximately five minutes before you proceed with these instructions.
3. Remove the two screws that secure the module to the front rails of the rack.
4. Carefully pull the module from the rack until it is stopped by the safety latches.
5. With one person holding each side, release the safety latches on both sides of the module and
pull the module out of the slide rail (see Figure B-10).
6. Place the module on a flat, stable surface.