User`s guide

Using Silicon Graphics Prism Modules with a Rack
007-4701-003 193
6. Secure the module to the rack by inserting a 10-32 x 1/2-inch Phillips screw in the top hole
of each chassis ear (see Figure B-9).
Figure B-9 Securing the Module to the Rack
Adjusting the Position of the Rackmounted Module
Once the module is installed in the rack, you can adjust the position of the module in the rack (up
and down, side-to-side). To adjust the position of the module, loosen the front mounting screws,
adjust the module to the desired position, then tighten the mounting screws.
Caution: Do not lift the module by its bezel; it is not designed to handle the weight of the module.
Instead, use the chassis ears to move the module (see Figure B-9).
2
3
4
5
6
7
1
8
9
10
10-32 x 1/2-inch screws
2
T
M
!