User`s guide

Using Silicon Graphics Prism Modules with a Rack
007-4701-003 189
5. Insert the front and rear brackets of one of the slide rails between the rack rails and the bar
nuts, as shown in Figure B-6.
6. Tighten the screws on the front- and rear-end of the rails. Do not tighten firmly at this point,
because all screws will be firmly tightened once the module is installed in the rack.
7. Repeat steps 5 and 6 to attach the second slide rail to the other side of the rack.
Figure B-6 Attaching the Slide Rail to the Rack
3
2
1
4
5
6
7
3
2
1
4
5
6
7
Tighten
screws
Slide rail assembly
Rack rail
Bar nut