User`s guide

182 007-4701-003
B: Installing Silicon Graphics Prism Modules Into a Rack
Preparing the Optional Slide Rail Assemblies
The slide rail assembly consists of a chassis rail and a slide rail. You need to remove the chassis
rail from the slide rail so that you can install a mounting bracket to the slide rail and attach the
chassis rail to the module (see “Preparing the Module” on page 185). To remove the chassis rail
from the slide rail, follow these steps:
1. Remove the two slide rail assemblies and the rear mounting brackets from the shipping
container.
2. Extend each slide rail assembly until the safety latch snaps into place.
3. Press the safety latch and remove the chassis rail from the slide rail, as shown in Figure B-1.
Figure B-1 Removing the Chassis Rail from the Slide Rail
Safety latch
Safety latch
Slide rail
Chassis rail