User`s guide

Using Silicon Graphics Prism Modules with a Rack
007-4701-003 179
Using Silicon Graphics Prism Modules with a Rack
This section describes how to install or remove a module in a rack using slide rails.
This rackmounting information is found in the following sections:
• “Rackmounting with Optional Slide Rails” on page 179
• “Removing a Rail-Mounted Module from a Rack” on page 194
Rackmounting with Optional Slide Rails
This section describes how to rackmount modules with slide rail assemblies and includes the
following topics:
• “Determining Module Space Requirements” on page 180
• “Slide Rail Mounting Hardware” on page 181
• “Preparing the Optional Slide Rail Assemblies” on page 182
• “Preparing the Module” on page 185
• “Determining Where to Attach the Slide Rail in the Rack” on page 186
• “Attaching the Slide Rail to the Rack” on page 187
• “Installing Clip Nuts in Rack Rails” on page 190
• “Installing the Module in the Rack” on page 191
• “Adjusting the Position of the Rackmounted Module” on page 193