User`s guide

92 007-4701-003
4: Installing and Removing Customer-Replaceable Units
9. Remove the lower PCI/PCI-X support bracket by unscrewing the four Phillips
screws, as shown in Figure 4-12.
Figure 4-12 Removing the XG2N Graphics Card Bracket
10. Undo and remove the two screws that hold the card to the back panel, as shown in
Figure 4-13.
Caution: Each graphics card has a 7-pin synchronization cable connected from the PCI
riser board to the underside of the graphics card. Be careful not to pull the graphics card
away from the board too far as you remove it.
11. Pull the card gently out of the main connector on the riser board until it is clear of
the back panel and main connector.
12. Carefully rotate the board over and disconnect the 7-pin keyed synchronization
cable from the bottom of the graphics board (it attaches the graphics card assembly
to the PCI riser board). See Figure 4-14 on page 94.
13. Place the graphics card on an ESD-safe surface or in a protective bag.
!