User`s guide

Installing Fire GL1 21
2. Click
Start Installation
.
Note:
The installation routine now checks if your Windows NT 4.0
is correctly updated with Service Pack 4. If not, you are prompted
if you want to install the drivers and Service Pack 4 at this time –
if the appropriate language version is available on the SuperCD.
If the SuperCD cannot install the Service Pack to your system, the
driver installation aborts. Obtain Windows NT Service Pack 4 from
Microsoft, update your Windows NT4.0, and run the the Quick
Start utility again.
3. Click the button corresponding to the type of installation you
want. If you select
Custom
, a list of software components will
be displayed. Select the check boxes to specify the components
you want to install.
4. Click
Next
to continue the installation.
5. When the
DIAMOND Install
dialog displays the components
to be installed click on
Next
. (Depending on which
components you chose different windows might appear. Click
on the corresponding buttons to continue the installation.)
6. When the
Installation complete
message appears click
Next
again. This will restart your computer.
7. Click
Start > Settings > Control Panel > Display >
Settings
, or right-click on the Windows desktop, select
Properties
and
Settings
.
8. Set the resolution, color depth, and refresh rate that best suit
your requirements and your monitor's performance.
9. Click
OK
.
Note:
You can select the refresh rates individually for each
monitor in the
Monitor
dialog of the
Display Properties
menu.
However, you can set the refresh rate for the monitor on your first
or primary display adapter only in the
Settings
dialog.