User`s guide

Installing Fire GL1 19
I
NSTALLING
S
OFTWARE
Now that you have installed the Fire GL1 hardware and rebooted
your computer, complete your installation using the following
directions for your operating system.
You will need to install a package of basic drivers
♦
if you install the card to your system
♦
if you are re-installing or upgrading your operating system
Important
— You must have Microsoft Windows NT Service Pack
4 installed prior to installing the Fire GL1 drivers. The Service Pack
is available from Microsoft's web page, www.microsoft.com. For
most languages you can also perform the Service Pack 4 update
from the SuperCD when you run the Quick Start utility.
To install or remove the Fire GL1 drivers, you need administrator
rights or you must be logged on as a user with administrator rights
under Windows NT.
General Information
Before installing the Diamond Fire GL1 video driver, close all open
applications and disable any anti-virus software that is running on
your computer until the driver installation is complete!
To install or uninstall the Fire GL1 drivers, you need administrator
rights or you must be logged on as a user with administrator rights
under Windows NT.
The Diamond installation dialog will display in English if your
operating system’s language is not supported.
Note:
If you have added Fire GL1 cards to your system for a
multi-monitor configuration you do not need to install the
software drivers again for each card. Go to
MultiScreen
in the
Display Properties
menu to enable and set up your multi-
monitor configuration.