User`s guide

4 Quick Installation
Note: If the previously installed graphics card has any additional
software installed, it should also be removed at this point.
4 Turn off your system and remove the old graphics card.
Quick Installation
Experienced users and system administrators can follow these brief
instructions for installing the FireGL™ card in the shortest possible time.
Detailed hardware and software installation instructions are given in the
next two sections.
To perform a quick installation
1 Uninstall the drivers and software for your old graphics card if you
have not already done so.
Note: If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a multiple-
monitor setup, disable it.
2 Shut down and disconnect your computer system.
3 Remove any previously installed card.
4 Install your new FireGL™ card.
5 Reassemble and connect your computer system.
6 Install the FireGL™ drivers and configuration software from the ATI
Installation CD-ROM by doing one of the following:
• Run through the automatic
ATISETUP utility; or
•
Start > Run > X:\SETUP.EXE (where X is the drive letter of
your CD-ROM drive).