Bluetooth Stereo Earphones Operation Manual
Thank you for purchasing theSH805B Bluetooth Stereo Earphones. Please read all instructions carefully before using and retain this manual for future use and reference. PACKAGE CONTENTS . Bluetooth Stereo Earphones . USB Charging Cable . 2 Extra Sets of Ear Cushions . Operation Manual KEY FEATURES . Compatible with Bluetooth-enabled devices .
. Volume control SAFETY INSTRUCTIONS Keep the unit away from heat sources. Direct sunlight， humidity，water and any other liquids. Do not operate the unit of it has been exposed to water, moisture or any other liquids to prevent against electric shock, explosion and/or injury to yourself and damage to the unit. Do not use the unit if it has been dropped or damaged in any way. Repairs to electrical equipment should only be performed by a qualified electrician.
Do not puncture or harm the exterior surface of the product in any way. Keep the unit free from dust. lint. etc. Do not use this unit for anything other than its intended use or purpose. Doing so may damage the device. This product is not a toy. Keep out of reach of children. Do not use the headset at excessive levels as this may damage hearing. Do not expose batteries, battery pack, or batteries to installed to excessive heat, such as direct sunlight or open flame.
FEATURES/PARTS I . Power On/Off Multifunction Button Answer /End Cal 2. Indicator LED 3. Volume Up/Next Track 4. Volume Down/Previous Track 5. Charging Port 6. Microphone CHARGING THE EARPHONES The earphones come with a built-in rechargeable battery. Before using it for the first time, we recommend you charge the battery fully.
cable to charge the headphones. Connect the USB cable to a computer USB port and the USB plug to the charging jack of the headset. The red LED light will illuminate while the earphones are charging A full charge of the battery takes around 2 hours. When the battery is fully charged, the LED light will turn blue. Disconnect the headset at this point. The headset will then be ready for use. When the battery is low, the LED will flash red and emit three tones every 20 seconds.
VOICE PROMPT The ear buds will notify you of status by speaking “Power On", “Power Off", And “Pairing Successful" when applicable. TURNING HEADSET ON/OFF Power On: Press and hold the Power On/Off button for 3seconds until the LED flashes blue. Power Off: Press and hold the Power On/Off button for 5seconds until the LED flashes red. In order to save power, the headset will automatically turn off if not paired with a device after 10 minutes.
PAIRING THE EARPHONES 1 . Ensure the earphones are turned off. If they are not, please turn off the earphones first before pairing. 2. Press and hold the Power On/Off button for 5-7seconds until the LED flashes red and blue. This will indicate your earphones are now in pairing mode. 3. Place the earphones and the Bluetooth device to which you would like to pair it within the operating distance. We recommend keeping the two devices no further than 3 feet apart. 4.
select the earphones 'BTEARBUDS' from the list of available Bluetooth devices. 6. Please note, pairing mode on the earphones will ast for two minutes. If no devices are paired after two minutes, the earphones will automatically switch off. 7. If pairing is unsuccessful, turn off the earphones first and repair following the aforementioned steps. Once you have paired the earphones with a device.
going through the pairing or PIN process on up to two devices. During use, the battery life of your earphones is visible on your iPhone or iPad screen. LISTENING TO MUSIC Once the earphones are paired to your device, you can stream music wirelessly to the earphones. Select the track you wish to listen to on your device to listen via earphones. Should you encounter any problems while streaming, please refer to your device's user manual.
Please note the following functions. 1. Increase Volume: Press the Vol + Button once 2. Decrease Volume: Press the Vol - Button once 3. Play/Pause: Press the Multifunction Button 4. Previous Track: Press and hold the Vol - Button 5. Next Track: Press and hold the Vol + Button CARE AND MAINTENANCE . Do not expose the headset to liquid, moisture, or humidity to avoid damage to the product's intimal circuitry. . Do not use abrasive cleaning solvents to dean the unit. .
temperatures as this will shorten the life of the electronic device, destroy the battery, and/or distort certain plastic parts. . Do not dispose of the earphones in fire as they may explode or combust. . Do not expose the headset to contact with sharp objects as this will cause scratches and damage . Do not let the earphones fall from high places. as doing so may damage the internal circuitry. . Do not attempt to disassemble the earphones.
Bluetooth:V3.0 + EDR, Class II Bluetooth Profiles: HSP, HFP, A2DP and AVRCP Operating Distance: Up to 33ft (10 m) Play Time: Up to 4 Hours Talk Time: Up to 5 Hours Standby Time: Up to 50 Hours Charging Input: DC 5V. -140mA Charging Time: ~2 Hours 1. FCC Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with part 15 of the FCC rules.
this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: The manufacturer is not responsible for ANY interference, for example RADIO or TV interference, caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
Warranty The condition of this warranty and supplier's responsibilities under this warrant/ are as follows: Warranty is non-transferable and is limited to the original purchaser only. - You must be able to prove the date of original purchase of the unit with a dated receipt. - Supplier's responsibility shall be limited to there pair or replacement of the product at if’s sole discretion.
- Specifically exempt from any warranty are limited-life consumable components subject to normal wear and tear such as batteries, decorates and other accessories. - Supplier is not responsible, for failure resulting from accident, abuse, misuse, or any unauthorized repair or modification. - Modification and repair of the unit should be done by an authorized and qualified service center or returned to the manufacturer.
