Instruction manual

60
21. To select the slopes time unit, the value between 0 and 2 must be
assigned as per the below table:
Slopes time unit Serial value
Second 0
Minute 1
Hour 2
22. To select the 2
nd
retransmitted output selection, the value between 0
and 2 must be assigned as per the below table:
2
nd
retransmitted
output selection
Serial value
None 0
Process variable 1
Setpoint 2
23. To select the 2
nd
retransmission output, the value between 7 and 11
must be assigned as per the below table:
2
nd
retransmission
output
Serial value
0 .. 5 V 7
1 .. 5 V 8
0 .. 10 V 9
0 .. 20 mA 10
4 .. 20 mA 11
24. To select the Power fail, the value between 0 and 2 must be
assigned as per the below table:
Power Fail Serial value
Continue 0
Reset 1
Ramp 2
25. To select the Segment time basis, the value between 0 and 2 must
be assigned as per the below table:
Segment time basis Serial value
Second 0
Minute 1
Hour 2
26. To select the logic output status of segment #, the value between 0
and 2 must be assigned as per the below table:
Logic output status of
segment #
Serial value
Closed 0
Open 1
disabled 2