Instruction manual

56
444 445 Prog. 3 segment 13 - OP4 digital output
OP. 4
R/W
26
445 446 Prog. 3 segment 14 - Time
ti.14
R/W
446 447 Prog. 3 segment 14 - Setpoint
S.P.14
R/W
447 448 Prog. 3 segment 14 - OP3 digital output
OP. 3
R/W
26
448 449 Prog. 3 segment 14 - OP4 digital output
OP. 4
R/W
26
449 450 Prog. 3 segment F - Setpoint
S.P. F
R/W
450 451 Prog. 3 segment F - OP3 digital output
OP. 3
R/W
26
451 452 Prog. 3 segment F - OP4 digital output
OP. 4
R/W
26
Notes:
1. This function may be used only with a suitable configuration outputs
are set properly.
2. The OP1 value can be only assigned when the controller is working
in Manual mode.
3. The Local Setpoint (Wloc) can be read at the both JbuS addresses 4
and 5. It only depend on the compatibility with the other Athena
Controls instruments.
4. The above parameters can only be read when the Adaptive Tuning is
launched. The Td derivative time is not shown but it can be simply
calculated as the ¼ of the Ti integral time (Td = Ti/4).
5. When the Program status is requested, the instrument replies as per
the below table:
Program status Serial value
Reset 0
Run 1
Hold 2
Automatic Hold 3
Program End 4
6. To select the Program command, the value between 0 and 1 must be
assigned as per the below table:
Program command Serial value
Reset 0
Start 1
7. To select the input type, the value between 0 and 24 must be
assigned as per the below table:
Input type Serial value
TC J 0
TC K 1
TC L 2
TC S 3
TC R 4
TC T 5
TC B 6
TC N 7
TC NI 8
TC W3% 9
TC W5% 10
TC E 11
Custom 12
RTD 1 13