Instruction manual

45
14. To select the serial comm.s baud rate, the value between 0 and 3
must be assigned as per the below table:
Baud Rate Serial value
1200 0
2400 1
4800 2
9600 3
15. To select the OP5 retransm. output range, the value between 0 and 1
must be assigned as per the below table:
Variable Serial value
0…20mA 0
4…20mA 1
16. To select the retransmitted variable (PV or SP), a value between 0
and 1 must be assigned as per the below table:
Variable Serial value
PV 0
SP 1
17. To select the Timer/Start-up operating mode, a value between 0 and
7 must be assigned as per the below table:
Timer/Start-up operating mode Serial value
Disabled 0
Start-up 1
Counting inside band 2
Counting inside band / End mode OFF 3
Counting when launched 4
Counting when launched / End mode OFF 5
Counting disable when launched 6
Stand-by Setpoint 7
18. To select the Timer action, a value between 0 and 7 must be
assigned as per the below table:
Timer action Serial value
Launch OP3 status Time
By Keypad OFF Second 0
By Keypad ON Second 1
Key +
at power on
OFF Second 2
Key +
at power on
ON Second 3
By Keypad OFF Minute 4
By Keypad ON Minute 5
Key +
at power on
OFF Minute 6
Key +
at power on
ON Minute 7