Installation manual

Table of Contents
900M050U00  Athena Controls, Inc. v
11.4.3 Configuring Individual Recipe Segments............................................. 11-11
11.4.3.1 Specifying the Ramp Time for Each Step of a Multi-Step Recipe.. 11-11
11.4.3.2 Linking a Ramp Period to an Alarm .............................................. 11-11
11.4.3.3 Specifying the Setpoint for Each Soak in a Multi-Step Recipe....... 11-12
11.4.3.4 Specifying the Length of Each Soak in a Multi-Step Recipe.......... 11-12
11.4.3.5 Linking a Soak Period to an Alarm ............................................... 11-13
12. Supervisor Parameters – Recommended......................................... 12-1
12.1 Introduction ................................................................................................. 12-1
12.2 Specifying What Happens When an Input Is Bad .........................................12-2
12.3 Defining the Loop Break Time...................................................................... 12-2
12.4 Viewing the Highest and Lowest Process Value Received Since Last Reset 12-3
12.5 Resetting All Parameters to the Defaults......................................................12-3
13. Calibration Function – Not Required for Configuration................... 13-1
13.1 Introduction ................................................................................................. 13-1
13.2 Calibration Is Not Usually Required ............................................................. 13-1
13.3 Menu Items ................................................................................................. 13-2
14. Option Parameters – Required if Using Options.............................. 14-1
14.1 Introduction ................................................................................................. 14-1
14.2 Options Supported....................................................................................... 14-1
14.3 Summary of Option Parameters................................................................... 14-3
14.4 Specifying the Option Card.......................................................................... 14-5
14.5 Configuring Serial Communications Parameters for MODBUS.....................14-6
14.5.1 Introduction........................................................................................... 14-6
14.5.2 Assigning a Unique Controller Address When MODBUS is Used .......... 14-6
14.5.3 Selecting the Baud Rate Applicable to MODBUS Communications ....... 14-6
14.5.4 Selecting the Parity When MODBUS is Used........................................ 14-7
14.5.5 Selecting the Sequence for 32-bit IEEE Registers When
MODBUS Is Used ................................................................................ 14-7
14.6 Configuring Serial Communication Parameters for Athena Plus Protocol ..... 14-8
14.6.1 Introduction........................................................................................... 14-8
14.6.2 Assigning a Unique Controller Address When Athena Plus is Used....... 14-8
14.6.3 Selecting the Baud Rate Applicable to Athena Plus Communications.... 14-8
14.6.4 Selecting the Number of Data Bits and Stop Bits,
and the Parity Applicable to Athena Plus Communications ....................14-9
14.6.5 Transmission Delay When Athena Plus is Used....................................14-9
14.7 Configuring Auxiliary Output Parameters ................................................... 14-10
14.7.1 Introduction......................................................................................... 14-10
14.7.2 Selecting the Value to be Transmitted................................................. 14-10
14.7.3 Scaling the Auxiliary Analog Output .................................................... 14-10
14.8 Configuring the Contact/Digital Input Parameter......................................... 14-11
14.8.1 Introduction......................................................................................... 14-11
14.8.2 Selecting Contact/Digital Input Function.............................................. 14-11