Installation manual

900M050U00 Athena Controls, Inc. 7-1
7. Output Parameters – Required
7.1 Introduction
The 1ZC, 16C, 18C, and 25C controllers are available with one or two standard outputs
(relay, pulsed voltage, or analog, depending on the model ordered). The way that these
standard outputs are used is determined by the way you configure the parameters in the
OutPOutP (output) menu (shown in the table below). An additional analog output can be
ordered as an option. Use of this auxiliary output is specified using the option menu
described in 14.7.
The output menu is available only when the security access level is set to CnF9CnF9
(configuration) or FACtFACt (factory).
27
Item Parameter Name When Displayed
01.ty01.ty
Output 1 Type always
01.Ac01.Ac
Output 1 Action only if Output 1 Type is On/Off or PID
01.cY01.cY
Output 1 Cycle Time
O1.LLO1.LL
Output 1 Low Limit
O1.HLO1.HL
Output 1 High Limit
only if Output 1 Type is PID
01.AA01.AA
Output 1 Alarm Action
O1.AOO1.AO
Output 1 Alarm Operation
O1.dLO1.dL
Output 1 Alarm Delay
O1.IHO1.IH
Output 1 Alarm Inhibit
O1.SPO1.SP
Output 1 Alarm Setpoint
only if Output 1 Type is Alarm and the
controller is a 16C (also applies to 1ZC)
02.ty02.ty
Output 2 Type always (assuming the hardware supports a
second output)
02.Ac02.Ac
Output 2 Action only if Output 2 Type is On/Off or PID
02.cY02.cY
Output 2 Cycle Time
O2.LLO2.LL
Output 2 Low Limit
O2.HLO2.HL
Output 2 High Limit
only if Output 2 Type is PID
02.AA02.AA
Output 2 Alarm Action
O2.AOO2.AO
Output 2 Alarm Operation
O2.dLO2.dL
Output 2 Alarm Delay
O2.IHO2.IH
Output 2 Alarm Inhibit
O2.SPO2.SP
Output 2 Alarm Setpoint
only if Output 2 Type is Alarm and the
controller is a 16C (also applies to 1ZC)
27
The access level in all new 16C, 18C, and 25C controllers is set to CnF9CnF9 at the factory. If you cannot
see the output menu, the access level has been changed to a more restrictive level. Instructions for
changing the access level are in Section 17.