Installation manual

Series C Controller Configuration and Operation Manual
6-6  Athena Controls, Inc. 900M050U00
6.3.3 Blanking the Display of the Setpoint When a Linear Input Is Used
If you do not want the setpoint to be displayed all the time (while the controller is
operating normally), then use the Setpoint Display Blanking parameter to specify the
length of time the setpoint should be displayed before being hidden (“blanked”). The
setpoint display will remain blank until any key is pressed. Pressing any key will cause
the controller to display the setpoint again. The setpoint will remain on display until the
period specified here has elapsed.
Parameter Name:
Setpoint Display Blanking (C1)
Name as Displayed
:
bLAnbLAn
Used By:
all except 1ZC
When Displayed:
always
Range:
OFFOFF off
10 to 9999 seconds
Default:
off
Description:
Used to specify the number of seconds the setpoint should be
displayed before the display of the setpoint goes blank.