Installation manual

Series C Controller Configuration and Operation Manual
5-8  Athena Controls, Inc. 900M050U00
5.5.2 Procedure for Viewing the Currently Selected Input Type
To view the input type currently set for the controller:
1. Access the configuration menus by pressing the key until a string of letters is
displayed on the top line (approximately three seconds).
2. If a menu name other than InPInP is displayed, press the key until InPInP is displayed
on the top line.
3. If a parameter name other than tYPEtYPE is displayed on the lower line, press the
key repeatedly to step until the tYPEtYPE parameter is displayed. The display of the
parameter will alternate with the currently configured choice for this parameter. For
example, in an out-of-the box controller, tYPEtYPE will alternate with the display of JJ (for J
thermocouple).
5.5.3 Procedure for Changing the Input Selection
To change the input type selection:
1. Press the key or key to cycle through the input type choices until the input
type you want is displayed on the lower line.
2. Press the key once to write the configuration change to the controller’s EEPROM
and display the next parameter (bias) in the input menu.
What’s next after you have specified the input type?
If you chose an RTD or thermocouple input type, go to 5.6.
If you chose a linear input type go to 5.7.