Installation manual

Table of Contents
900M050U00  Athena Controls, Inc. iii
5. Input Parameters – Required.................................................................. 5-1
5.1 Introduction ................................................................................................... 5-1
5.2 Calibration Must Be Appropriate for Input Type.............................................. 5-1
5.3 Input Jumper Settings Must Match Input Type ...............................................5-2
5.4 Input Menu Parameter List............................................................................. 5-4
5.5 Specifying the Input Type ..............................................................................5-6
5.5.1 Parameter Used .....................................................................................5-6
5.5.2 Procedure for Viewing the Currently Selected Input Type........................5-8
5.5.3 Procedure for Changing the Input Selection............................................5-8
5.6 Configuring Input Parameters for RTD and Thermocouple Input Types..........5-9
5.6.1 Applying a Bias to the Temperature Input................................................ 5-9
5.6.2 Specifying the Setpoint Range When a Temperature Input is Used....... 5-10
5.6.3 Applying an Input Filter When a Temperature Input is Used .................. 5-10
5.7 Configuring Input Parameters for Linear Inputs............................................ 5-12
5.7.1 Applying a Bias to the Linear Input........................................................ 5-12
5.7.2 Scaling the Linear Input ........................................................................5-13
5.7.3 Specifying the Setpoint Range When a Linear Input Is Used ................. 5-14
5.7.4 Applying an Input Filter When a Linear Input is Used ............................ 5-14
6. Display Parameters – Required.............................................................. 6-1
6.1 Introduction ................................................................................................... 6-1
6.2 Configuring Display Parameters for RTD and Thermocouple Input Types ......6-3
6.2.1 Choosing the Decimal Position When a Temperature Input Is Used ........6-3
6.2.2 Specifying the Display Filter When a Temperature Input Is Used.............6-3
6.2.3 Choosing the Unit of Measure When a Temperature Input Is Used.......... 6-4
6.2.4 Blanking the Display of the Setpoint When a Temperature
Input Is Used........................................................................................... 6-4
6.3 Configuring Display Parameters for Linear Input Types..................................6-5
6.3.1 Choosing the Decimal Position When a Linear Input Is Used...................6-5
6.3.2 Specifying the Display Filter When a Linear Input Is Used.......................6-5
6.3.3 Blanking the Display of the Setpoint When a Linear Input Is Used...........6-6
7. Output Parameters – Required............................................................... 7-1
7.1 Introduction ................................................................................................... 7-1
7.2 Specifying the Output Type............................................................................ 7-3
7.3 Choosing the Output Action for On/Off Control...............................................7-4
7.4 Configuring Output Parameters for PID Control .............................................7-5
7.4.1 Choosing the Output Action for PID Control ............................................7-5
7.4.2 Specifying the Cycle Time for PID Control............................................... 7-6
7.4.3 Specify the PID Output Range ................................................................7-7
7.5 Configuring Output Parameters for Alarm Annunciation – 1ZC and 16C Only. 7-9
7.5.1 Choosing the Alarm Action......................................................................7-9
7.5.2 Choosing the Alarm Operation..............................................................7-10
7.5.3 Specifying the Alarm Delay – Optional ..................................................7-11
7.5.4 Inhibiting the Alarm– Optional............................................................... 7-11
7.5.5 Specifying the Alarm Value (Setpoint)................................................... 7-12