Installation manual

Series C Controller Configuration and Operation Manual
4-8  Athena Controls, Inc. 900M050U00
4.5 Using Factory Defaults
Sections 5 through 14 include the factory default value for every parameter. If you want
to use the default for a particular parameter, you do not have to take any action.
For example, suppose you want to use the defaults for the setpoint low limit and the
setpoint high limit in the input menu. Also, you know that the defaults for every
parameter in the display menu are OK for your application.
In this case, when you work your way through the input menu and get to the setpoint
limits, you can press the key as each setpoint limit parameter is displayed to accept
the current value and move past them to the input filter parameter.
After using the and keys to specify an input filter value, you press the key
to write the new value to the database. The first parameter in the input menu (TypeType) will
again be displayed.
You press the key to display the abbreviated name of the next menu. It is dSPLdSPL
(display). If you know you are satisfied to use the defaults for all the display menu
parameters, you do not have to press the key to cycle through the display
parameters.
You can immediately press the key again to move on to the OutPOutP (output) menu.