Installation manual

Series C Controller Configuration and Operation Manual
ii  Athena Controls, Inc. 900M050U00
1.9 What Happens When You Power Up the Controller ..................................... 1-17
1.9.1 Outputs.................................................................................................1-17
1.9.2 Display ................................................................................................. 1-17
1.9.3 Setpoint................................................................................................1-17
1.10 Configuration and Startup Activities .............................................................1-18
2. User Interface .......................................................................................... 2-1
2.1 Overview.......................................................................................................2-1
2.2 Display .......................................................................................................... 2-2
2.2.1 When in a Control Mode .........................................................................2-2
2.2.2 During Configuration...............................................................................2-4
2.2.2.1 Introduction.........................................................................................2-4
2.2.2.2 Menus Available..................................................................................2-4
2.3 LEDs.............................................................................................................2-6
2.3.1 On 16C, 18C, 25C Controllers ................................................................2-6
2.3.2 On 1ZC Controller ..................................................................................2-7
2.4 Using the Keypad .......................................................................................... 2-8
2.4.1 Key Functions......................................................................................... 2-8
2.4.2 Displaying and Changing the Setpoint................................................... 2-10
2.4.3 Putting Controller in Standby Mode....................................................... 2-10
2.4.4 Returning Controller to Normal Operation ............................................. 2-11
2.4.5 Putting Controller into Manual Mode and Changing the Output Values..2-11
2.4.6 Starting, Pausing, and Terminating Recipe Execution ...........................2-13
2.4.7 Clearing Latched Alarms.......................................................................2-15
2.4.8 Working in Configuration Mode............................................................. 2-16
2.4.8.1 Entering and Exiting Configuration Mode........................................... 2-16
2.4.8.2 Procedure for Viewing and Changing a Configuration
Parameter Value ...............................................................................2-16
2.4.8.3 Configuration Example...................................................................... 2-17
3. Configuring the Controller – Quick Setup Instructions
for PID Control........................................................................................ 3-1
3.1 Introduction ................................................................................................... 3-1
3.2 Quick Instructions.......................................................................................... 3-2
4. General Information About Configuration Parameters......................... 4-1
4.1 Information in This Section ............................................................................ 4-1
4.2 How to Use Sections 5 through 14................................................................. 4-2
4.3 Information Provided About Each Parameter ................................................. 4-3
4.3.1 Summary................................................................................................4-3
4.3.2 Effect of Linear Input on Numerical Ranges ............................................4-3
4.4 Menu and Parameter Display Sequence........................................................4-5
4.5 Using Factory Defaults ..................................................................................4-8
4.6 Parameter Identifiers Used by Multi-Comm Software .....................................4-9