Installation manual

General Information About Configuration Parameters
900M050U00  Athena Controls, Inc. 4-5
4.4 Menu and Parameter Display Sequence
The menus and parameters are displayed in the sequence shown below. When the
controller is powered up, the menu sequence starts with the InPInP (input) menu. Within
the menus, the parameters are displayed in the sequence shown below. However, not
all parameters apply to every control strategy.
If a parameter does not apply to a particular control strategy, then that parameter will not
be displayed. For example, if you specify that the output 2 type is OFFOFF, then the other
parameters used to configure output 2 will not be displayed.
When you have gone into the menu system and then exited the menus, the controller
“remembers” where you were. The next time someone accesses the menu system, the
controller will display the menu from which you left. When the key is pressed, the
parameter displayed will not be the first one in the menu. Instead, the last parameter
accessed during the most recent configuration session (since power up) will be
displayed. For example, if you exited the menu system (or were timed out) when the
dSPLdSPL (display) menu’s UnitUnit parameter was on display, then the next time the menu
system is accessed, the dSPLdSPL menu UnitUnit parameter will be the first parameter
displayed.
Displayed
Abbreviation
(menu name) Parameters
Access
Levels
Described
In
InPInP
(input)
tYPEtYPE
bIASbIAS
SCL.LSCL.L
SCL.HSCL.H
SP.LLSP.LL
SP.HLSP.HL
I.FILI.FIL
cnF9cnF9 (configuration) and
FACtFACt (factory)
5
dSPLdSPL
(display)
dEC.PdEC.P
d.FILd.FIL
UnitUnit
bLAnbLAn
cnF9cnF9 (configuration) and
FACtFACt (factory)
6
OutPOutP
(output)
01.tY01.tY
01.Ac01.Ac
01.cY01.cY
01.LL01.LL
01.HL01.HL
01.AA01.AA
01.A001.A0
01.dL01.dL
01.IH01.IH
01.SP01.SP
02.tY02.tY
02.Ac02.Ac
02.cY02.cY
02.LL02.LL
02.HL02.HL
02.AA02.AA
02.A002.A0
02.dL02.dL
02.IH02.IH
02.SP02.SP
cnF9cnF9 (configuration) and
FACtFACt (factory)
7
CtrLCtrL
(control)
db.1db.1
HYS.1HYS.1
db.2db.2
HYS.2HYS.2
Pb1Pb1
Pb2Pb2
dErdEr
OFFSOFFS
IntInt
USErUSEr (user) and
cnF9cnF9 (configuration) and
FaCtFaCt (factory)
8