Installation manual

Series C Controller Configuration and Operation Manual
4-2  Athena Controls, Inc. 900M050U00
4.2 How to Use Sections 5 through 14
You do not have to read the all of Sections 5 through 14. You can skip any sections
marked “optional” that do not apply to your control strategy. You can also skip some
parts of some of the required sections. The path you take as you read will be determined
by your control strategy.
For example, in Section 5 everyone needs to know about the information in 5.1, 5.2, 5.3,
5.4, and 5.5, so there are no stop signs to interrupt your reading. However, when you get
to the end of 5.5 you will see:
What’s next after you have specified the input type?
If you chose an RTD or thermocouple input type, go to 5.6.
If you chose a linear input type go to 5.7.
This means that you should look at either 5.6 or 5.7, but you do not have to read both. If
a parameter applies to both temperature and linear input types, the parameter description
will be repeated in 5.6 and 5.7.