Installation manual

User Interface
900M050U00  Athena Controls, Inc. 2-17
At this point you can:
• use the and keys to change the value of the newly displayed parameter, or
• if you like the current value of the parameter on display, you can press the key to
leave the displayed value unchanged and go on through the parameters in the
menu), or
• press the key once to go to the next menu, then use the key to step through
the parameters in that menu, or
• press the key repeatedly to display menus later in the cycle, or
• press and hold the key until the normal operating display returns to view.
If you do not press any key, eventually you will be timed out of the menu system. The
controller will revert to the operational display that was in view before you entered the
menu system.
2.4.8.3 Configuration Example
Suppose that once the controller is in operation you want to turn off setpoint blanking and
change the alarm 2 setpoint.
1. Press and hold the key (approximately three seconds) until CtrLCtrL is displayed on
the top line and the current mode on the lower line.
2. Press the or key until StbYStbY is displayed.
3. Press the key again. The display will show StbYStbY alternating with the process
value on the top line. The setpoint will be displayed on the lower line.
4. Press and hold the key until the abbreviated name of a menu is displayed on
the top line of the display.
• If no one has used the menu system since the controller was powered up, the
InPInP (input) menu will be displayed first.
• If someone has already accessed the menu system since startup, the menu
displayed will be the last one used.
5. To turn off setpoint blanking, press the key until the dSPLdSPL (display) menu name
is on the top line.
6. Press the key until the bLAnbLAn (setpoint blanking) parameter is displayed on the
lower line. The display of bLAnbLAn will alternate with the display of the current value.
(When setpoint blanking is on, a numeric value represents the number of seconds
that the setpoint will be displayed after a key press. When the time elapses, the
setpoint display will become blank.)
7. Press the key until OFFOFF is displayed for bLAnbLAn.