Installation manual

Series C Controller Configuration and Operation Manual
2-4  Athena Controls, Inc. 900M050U00
2.2.2 During Configuration
2.2.2.1 Introduction
When the key has been used to display a menu, you can configure the controller.
It is recommended that you put the controller in standby mode as described in 2.4.3
before going into configuration to change parameter values. Putting the controller in
standby will ensure that the outputs are off.
During configuration the top line of the display contains a menu name. The second line
of the display contains a parameter name, alternating with the current value. For
example, when the input menu input type parameter is accessed the display will show
InPInP alternating InPInP
tYPEtYPE with RtdRtd
2.2.2.2 Menus Available
To access the menus containing the configuration parameters, press the key until a
text string is displayed on the top line of the display (approximately three seconds). The
table below lists all the menus available.
Which of these menus is displayed depends on the access level set for the controller (as
described in 1.4). When a controller is first powered up the menus are displayed in the
sequence in which they are listed in the table. However, if you exit configuration, then
access the menus again, you will re-enter the cycle where you left it.
For example, if the OutPOutP (output) menu 02.tY02.tY (output 2 type) parameter is on display
when you exit configuration (or are timed out), then when you next access the menus, the
OutPOutP menu 02.tY02.tY parameter will the first one displayed.
To see all the parameters in all the menus, go to the referenced section of this manual.