Installation manual

I
Precautions
Warning
Remove power from the 1ZC controller before removing the terminal strip
from the controller.
Remove power from the 1ZC controller before removing the bezel and
circuit board assembly from the case.
Do not power up the 1ZC controller while the bezel and circuit board
assembly is out of the case.
Remove power from a controller before cleaning the exterior of the
controller.
Failure to observe these precautions can result in exposure to a potentially
lethal shock hazard.
All wiring should be done by an experienced technician and be installed in
accordance with national and local electrical codes. To avoid serious
personal injury and damage to equipment, follow all warnings and cautions
provided in the controller installation manuals.
Caution
If a controller shows signs of having been damaged during shipping, do not
power up or install the controller. Save all packing materials and report any
damage to the carrier immediately.
When the controller is powered up, the outputs may be activated. Consider
the effects on your process before powering up the controller.
We recommend placing the controller in standby mode until you have
configured the controller for your application.
Ø For instructions for putting a 16C, 18C, or 25C controller in standby
mode using the controller front panel, see 2.4.3 in this manual.
Ø For instructions for putting a 1ZC controller in standby mode using a
personal computer, see the manual supplied with the host software.