Installation manual
900M050U00 Athena Controls, Inc. 21-1
21. Index
A
access levels
described, 1-7, 17-1
menus, 2-5
active setpoint, 1-12
address for controller, 14-6, 14-8
alarm action, 1-13, 7-9, 9-3
alarm delay, 7-11, 9-5
alarm menu, 4-6, 9-1
alarm operation, 1-13, 7-10, 9-4
alarm option cards, 1-14
alarm outputs
configuration, 7-3, 7-9
described, 1-14
alarm setpoint, 7-12, 9-6
alarm value, 7-12, 9-6
alarms
configuration, 9-1, 9-3, 14-1
inhibiting, 7-11, 9-5
methods of annunciation, 1-3, 1-13, 9-1
types supported, 1-13
ALr menu. See alarm menu
analog auxiliary output, 14-2, 14-10
analog output cycle time, 7-6
Aout menu. See auxiliary output menu
Athena Plus protocol
configuring communication parameters, 14-3,
14-8
option cards, 14-1
parameter identifiers, 4-9, 15-1
auto reset, 1-8, 8-5, 8-6, 8-7, 16-1, 16-4, 16-5
automatic mode. See normal mode
Autotune
display, 2-2
parameters adjusted, 8-5
selection display, 1-5
Autotune damping menu, 1-7, 4-6, 10-1, 17-1
auxiliary output menu, 4-7, 14-2, 14-10
B
baud rate, 14-6, 14-8
bias, 5-9, 5-12, 20-2
blanking, 6-4, 6-6, 20-3
bumpless transfer, 1-2, 2-11
C
CAL menu. See calibration menu
calibrate all (ordering option), 3-1, 5-1, 13-1,
18-1, 20-1
calibration
linked to input type, 5-1
parameters, 13-1
permission to do, 1-7, 17-2
procedure, 18-1
calibration menu, 4-6
C-dI menu. See contact/digital input menu
changing
fixed output percentage, 2-11
input type, 5-1
mode, 2-10
setpoint, 2-10
checksum error, 19-2
communication
option card, 14-1, 14-3, 14-5, 14-6, 14-8
protocols supported, 1-4
configuration
display, 2-4
effect on output state, 2-4
example, 2-17
general information, 4-1
parameter sequence, 4-5
permission to access, 1-7, 17-1
sequence, 1-16, 1-18
standby mode, 1-6
viewing and changing values, 2-16
configuration (access level), 1-7, 17-2
configuring controllers
importance of sequence, 1-16
contact/digital input
menu, 4-6, 14-4, 14-11
option card, 1-12, 14-2
control menu, 4-5, 8-1
control types supported, 1-8
controller addresses, 14-6
CtrL menu. See control menu
current inputs, 5-1, 5-6, 5-12, 6-5, 13-1, 18-1
cycle time, 7-6