Installation manual

Series C Controller Configuration and Operation Manual
15-2  Athena Controls, Inc. 900M050U00
Code Parameter Name
Used
By Read/Write
Where
Described
11
Second Setpoint – RAM and
EEPROM
all except
1ZC
R/W 1.6
12 Second Setpoint – RAM only all except
1ZC
R/W 1.6
13 Remote Analog Setpoint all except
1ZC
R 1.6
14 Recipe Setpoint all R 1.6.
16 Output 1 Percentage all R See Note 1.
17 Output 2 Percentage all R See Note 1.
18 Output 1 Manual Mode Fixed
Output Percentage
all R/W 2.4.5
19
Output 2 Manual Mode Fixed
Output Percentage
all R/W 2.4.5
20 Output 1 Deadband all R/W 8.2.2
21 Output 1 Hysteresis all R/W 8.2.3
22 Output 1 Proportional Band all R/W 8.3.2
23 Output 2 Proportional Band all R/W 8.3.2
30 Rate/Derivative Action all R/W 8.3.3
32
Automatic Reset Integral
Action
all R/W 8.3.5
34 Manual Reset Integral Action all R/W 8.3.4
37 Output 2 Deadband all R/W 8.2.2
38 Output 2 Hysteresis all R/W 8.2.3
39 Autotune Damping all R/W 10.2
40 Recipe Option all R/W 11.2
41 Single-Setpoint Ramp Time all R/W 11.3.1
42 Ramp Time 1 all R/W 11.4.3.1
43 Ramp Time 2 all R/W 11.4.3.1
44 Ramp Time 3 all R/W 11.4.3.1
45 Ramp Time 4 all R/W 11.4.3.1
46 Ramp Time 5 all R/W 11.4.3.1
47 Ramp Time 6 all R/W 11.4.3.1
48 Ramp Time 7 all R/W 11.4.3.1
49 Ramp Time 8 all R/W 11.4.3.1
50 Ramp Event 1 all except
1ZC
R/W 11.4.3.2
51 Ramp Event 2 all except
1ZC
R/W 11.4.3.2
52 Ramp Event 3
all except
1ZC
R/W 11.4.3.2