Installation manual

Series C Controller Configuration and Operation Manual
14-12  Athena Controls, Inc. 900M050U00
14.9 Configuring the Remote Analog Setpoint Parameters
14.9.1 Introduction
If the card type is rASrAS, then the rASrAS (remote analog setpoint) menu is displayed. It
contains two parameters, which are described below.
14.9.2 Scaling the Input for the Remote Analog Setpoint
Parameter Name
: Remote Analog Setpoint Scale Low (G5) and Remote Analog
Setpoint Scale High (G6)
Name as Displayed
:
SCL.L SCL.L and SCL.H SCL.H
Used By:
all except 1ZC
When Displayed:
if the card type is remote analog setpoint
Range:
–1999 to 9999 (See Note 1 below.)
Default:
scale low: –1999
scale high: 9999
Description:
Used to specify the SV represented by the lowest (SCL.LSCL.L) and
highest (SCL.HSCL.H) possible remote analog input signal.
Note 1: The range is reduced when a linear input is used and the value of the dSPLdSPL
(display) menu dEC.PdEC.P (decimal position) parameter is not 0 (zero). See 4.3.2 for more
information about the effect of a linear input on numerical ranges.