Installation manual

Option Parameters
900M050U00  Athena Controls, Inc. 14-11
14.8 Configuring the Contact/Digital Input Parameter
14.8.1 Introduction
If the card type is SC.dISC.dI or di.aLdi.aL, then the C-dLC-dL (contact/digital input) menu is displayed.
It contains a single parameter, which is described below.
14.8.2 Selecting Contact/Digital Input Function
Parameter Name:
Contact/Digital Input Function (G7)
Name as Displayed:
Func
Used By:
all except 1ZC
When Displayed:
if the card type is contact/digital with alarm, or serial
communications with contact/digital switch
Choices:
dISdIS disabled
rS.rHrS.rH toggle between ramp/soak recipe run and hold
StbYStbY toggle between standby and normal (automatic mode)
S.SP.SS.SP.S enable use of second setpoint
Default:
disabled
Description:
Used to select the action that will result from
activating/deactivating the contact/digital input switch.
You have finished configuration of the contact/digital input option
parameter.
If you are using PID control, go to Section 16 for tuning.
If you are using on/off control, go to Section 17 for restricting
access.