Installation manual

Option Parameters
900M050U00  Athena Controls, Inc. 14-5
14.4 Specifying the Option Card
Parameter Name
: Installed Option Card (E8)
Name as Displayed
:
CardCard
Used By:
all except 1ZC
When Displayed:
always
Choices:
nonenone none
dI.ALdI.AL contact/digital input with alarm
ALrALr alarm
A.OutA.Out auxiliary output
rASrAS remote analog setpoint
Sc.dISc.dI serial communications with digital input
SErLSErL serial communications
Default:
1ZC, 18C, 25C: none
16C: serial communications
Description:
Used to choose the option menus to be displayed.
Effect on Other
Parameters:
Determines the individual option menus that are displayed.
What’s next after specifying the option card?
If you chose “none” for the option card, and you are using PID
control, go to Section 16 for tuning.
If you chose “none” for the option card, and you are using on/off
control, go to Section 17 for restricting access.
If you chose “serial” for the option card, and the controller
supports MODBUS, go to 14.5.
If you chose “serial” for the option card, and the controller
supports Athena Plus Protocol, go to 14.6.
If you chose “serial with digital input” for the option card, go to
14.6 and 14.8.
If you chose “auxiliary analog output” for the option card, go to
14.7.
If you chose “contact/digital input with alarm for the option card,
go to 14.8 and Section 9.
If you chose “alarm” and have not configured the alarms, go to
Section 9.
If you chose “remote analog setpoint”, go to 14.9.