Installation manual

Series C Controller Configuration and Operation Manual
14-4  Athena Controls, Inc. 900M050U00
Item Parameter Name When Displayed
a.outa.out (auxiliary output) menu; see 14.7
Out.UOut.U
Auxiliary Output Variable
SCL.LSCL.L
Auxiliary Output Scale Low
SCL.HSCL.H
Auxiliary Output Scale High
This menu is displayed if you chose AoutAout
as the card type. If the menu is displayed,
then all the parameters shown here are
included.
C-dlC-dl (contact/digital input) menu; see 14.8
FuncFunc
Contact/Digital Input Function
This menu is displayed if you chose dIALdIAL
or Sc.dISc.dI or dIndIn as the card type.
rASrAS (remote analog setpoint) menu; see 14.9
SCL.LSCL.L
Remote Analog Setpoint Scale
Low
SCL.HSCL.H
Remote Analog Setpoint Scale
High
This menu is displayed if you chose rASrAS as
the card type. If the menu is displayed, then
both the parameters shown here are
included.
ALrALr (alarm) menu; see Section 9
A1.AAA1.AA
Alarm 1 Action
A1.AOA1.AO
Alarm 1 Operation
A1.dlA1.dl
Alarm 1 Delay
A1.IHA1.IH
Alarm 1 Inhibit
A1.SPA1.SP
Alarm 1 Setpoint
A2.AAA2.AA
Alarm 2 Action
A2.AOA2.AO
Alarm 2 Operation
A2.dlA2.dl
Alarm 2 Delay
A2.IHA2.IH
Alarm 2 Inhibit
A2.SPA2.SP
Alarm 2 Setpoint
This menu is always displayed for
configuration of the action of the A1 and A2
front panel LEDs. Two alarm outputs are
available as an option. The action of the
optional alarm outputs follows the action of
the A1 and A2 front panel LEDs and is
configured using the ALrALr menu (see
Section 9).